CS II 300

  PR III UL 300 CS

Cost-effective production through automation

The PR III UL 300 CS unit represents a complete automation solution, which is used to further enhance the profitability of AMADA compact storage system.

Profitable production is made possible by the high level of automation.
Contributing to this are the three servo axes, which ensure the high positioning speeds of the individual sorting unit, as well as the idle position in close proximity to the machine: Both factors increase machine run time by minimizing idle time.

The handling for a variety of materials is performed by 32 individually controlled suction grippers. The vacuum technology and the minimal release height ensure reliable and careful handling of the material. The PR III UL 300 CS can therefore also be used for complex production parts and materials with sensitive surfaces.

The PR III UL 300 CS configuration is available to remove residual scrap and parts attached to micro-tabs.


  • High profitability
  • Maximized machine run times
  • Precise stacking permits automated down-stream processing
  • Reliable handling of various materials
  PR III UL 300
Part Size Max. 2500 x 1000 mm
Part Size Min. 150 x 150 mm
Sheet thickness 0,5 - 3,0 mm
Max. part weight 50 kg
Stocking area 3400 x 1400 mm (4 x Euro pallets)
Interrupt time 3 - 5 sec
Max. load and part table 4000 kg
Max. stocking height 450 mm
Max. speed pick up unit X-axis 180 m/min
Max. speed pick up unit Y-axis 90 m/min